Table of Contents
Advertisement
5. To remove the 3.5-inch storage drive, flex both sides of the conversion bracket and then remove the
drive out of the bracket. Do not touch the circuit board
Figure 60. Removing the storage drive from the bracket
6. To install a 3.5-inch storage drive, ensure that the conversion bracket is unfolded. To unfold the bracket,
do the following:
a. Remove pins
1
and install them into slots
Figure 61. Removing pins and installing them into slots
1
on the drive.
2
.
Chapter 7
.
Hardware removal and installation
85
Advertisement
Table of Contents
