Segoe Se Cite Ne Cases Veoibe Ae Tag Tice Ieee Erence Sey Bedi Age Dasa Taoessaney Mse Souatantaaees; Diregt Agcess Tuning Ciccoecedaeieaacelcnekd Vz Vabees Oa Ceaeucccaie Ccecvedsacvescueddecwiccoseaeeduatedoveeeute Essa Onres; Auto" Tuning Hisdcesssviesusedaciecsccdasaducectevscesastecwesssvasee Raven Soasecesaessehs Veugdeccwocsed Ves Succes Veewsaeeee - Pioneer VSX-D6025 Operating Instructions Manual

Press the POWER switch to the ON position.
Select TUNER with the INPUT SELECTOR.
Be sure to turn the TAPE 2 MONITOR button OFF when listening
to AM or FM broadcasts.
Switch ON the SPEAKERS button corresponding to the speakers
being used.
DIRECT ACCESS TUNING
FM auto stereo reception and monaural reception
Each time you press the MPX MODE button, the FM MONO indicator
in the display section lights or goes out.
© If an FM stereo broadcast is received when the FM MONO
indicator is out, the STEREO indicator lights, and sound is in stereo.
e lf an FM stereo broadcast is received when the FM MONO
indicator is lit, the sound will be monaural.
If there is interference during STEREO mode reception, switch to
FM MONO. The sound will become monaural but interference will
be reduced.
1. Select either FM or AM using the BAND FM/AM button.
2. Press the DIRECT ACCESS button
3. Input the desired station frequency using the STATION CALL
[eT ets:
AUTO TUNING
Auto tuning is convenient when you do not remember the frequency
of a desired station, or when you wish to find stations that you do not
normally listen to.
13 2 4
f@cef_-11ittI]ss Je
1. Use the BAND FM/AM button to choose either FM or AM.
22
<ARB1421>
she ma
4. Adjust the sound volume and tone as desired.
To cancel frequency input
Direct access is canceled when the DIRECT ACCESS button is pressed
again.
Under the following conditions direct access is canceled and the unit
returns to the condition in effect before direct access was selected:
Notes regarding direct access tuning
2. Press the TUNING MODE button and the AUTO TUNING indicator
lights.
3. Press the "+" or "~'' of the TUNING buttons.
® Pressing ''+'' causes scanning to take piace in the direction of
increasing frequency. Pressing ''—'' causes scanning to take place
in the direction of decreasing frequency.
¢ When a station is received, scanning will stop (the
indicator lights). If you wish to receive a different station, press
the TUNING button "+" or "'—"' again. :
° Pressing either of the TUNING (—, +) button during auto tuning
causes tuning to stop at the current frequency.
4. Adjust the sound volume and tone as desired.
NOTE:
* When Auto Tuning is used, correct reception may not be possible
for very distant stations or stations with very weak signals. In this
event, Manual Tuning is recommended.
° The [TUNED | indicator may not light with broadcasts received over
long distances, or when the broadcast signals are extremely weak.