Advertisement
TD-MXG9BK
Disassembly Procedures
W
Top cover removal
Remove the screws fastening both sides of the Top
cover and rear side.
2.
Remove the Top cover spreding both sides and lifting
the rear up.
=
Front panel block removal
Remove the Top cover.
Disconnect the connectors P101,P102,J401 ,J402, )403.
Remove the screw © on the bottom .
Release the 3 hooks @ and remove the front panel
block.
Figure 1 Bottom view of the front panel
Pwo
wy
Cassette mechanism block removal
Remove the front panel block.
Disconnect the connectors J408,J409.
Remove the 8 biue colored screws © © fixing the
mechanism.
=
Push the eject button and remove the cassette
mechanism block.
wy
>
=
NOTE
The cassette mechanism is grounded through the
bottom cover, so when chacking the operations with
the bottom cover removed {especially when checking
the signa! system), bé sure to ground the chassis by
using an alligator clip or other suitable gadget. Also,
this mechanism ts designed for pack sensing,
remember that it can not be operated without any
tape.
@
Cassette holder removal
Remove the cassette mechanism from the front panel
block.
2.
Remove the dampers.
Remove the holder spring from the holder bracket.
4.
Remove the cassette holder from the hoider bracket.
_
=
Figure3
Rear view of the front panel block
H
System controller PCB removal
Remove the front panel block.
2.
Remove the screw ©. and remove the PCB.
:
COE,
.
,
A
Mi Cassette lid removal
Open the doors and slide them in the direction of the
arrows.
Figure4
Cassette lids
2
=
1-6 (No. 20437)
Advertisement
