Advertisement
7. Removing the Laser Pickup
1} Remove the metal cover, tray assembly and the
clamp.
2) Remove the screw © from the Mecha Base
assembly.
3) Remove the Mecha Base assembly from the
rubber cushion @@.
4) Movethe Shaft stopper from the rest
position to the left side ©.
5)
Remove the Pickup Shaft from the Mecha
Base assembly.(Slide the Pickup shaft to the.
up side@)
6) Remove the CD Pick Unit with the shaft.
8. Installing the Laser Pickup (See page 1-14)
(See page1-15(Before installing the pickup)):
1) Connect the Flat wire with the connectors of .
APC (Automatic Power Control) P.C.Board.
2) While installing the @ in the CD Support, set
the shaft on the base hook®.
3) Install the Mecha Base assembly to the rubber
cushion @@.
Shaft stopper
Turn
A:
9. Removing the spindle motor
1) Remove the Mechanism assembly.'
2)
Remove the turntable, and remove the two
screws retaining the spindle motor.
3)
Remove the screw retaining the spindle and
the Feed Motor P.C. Board and unsolder it.
10.
1).
2).
3)
XLIMXG9BK'
yA
Spindie motor retaining screws
Turntable
ristalling the eanals motor
Tighten the 2 screws to the same torque. ,
Fasten the Spindle and the Feed Motor P. C.
Board with the screw and solder.
A
Install the turntable. When installing, press
_ straight down at the center of the turntable
_until the distance from the surface of the.
4)
mechanism: base to the top of the turntable is
ore 19. 42 0. imm.
After insertion is complete: bond the motor
- shaft and turntable together (at the section
» marked by an arrow in 1 the figure o on the left
- below).
:
5)
Use "LOCKTITE" #460 botaings agent, and
apply as little as possible. Take care not to allow
any excess bonding agent to get onto the
turntable. Be extremely careful not to allow
bonding agent to adhere to the motor bearings
(the section marked by an allow in the figure
on the right).
(No. 20436)1-11
Advertisement
