Advertisement
XL-MXG9BK
Disassembly Procedures —
1.
Removing the top cover
(1) Remove the 2 screws on both sides of the top
_ cover and the 4 screws on the rear side.
{2) Gently spread both sides of the topcoverto
the outside, lift up the rear section, and remove
the top cover. -
2.: Removing the tray
" (1)-Remove the top cover.
_ (2) Switch on the power of RX-MXG9BK .
Press the OPEN / CLOSE switch to bring the tray
forward and with the tray forward, switch off
the power.
(3) Remove the screw on the tray ®.
(4) Pull the tray toward the front to move it.
Note
If the power r does not come on due to
breakdown or the, insert a Philips screwdriver
"
———_-PBO2,PBOS
p90
through the hole at the bottom of the front:
panel and turn it counter-clockwise to bring the
tray forward @.
3.
Removing the front panel assembly
1) Remove the top cover.
1
é
Remove the connectors (P901) connecting with
Sawn
PSD
main P.C. Boards.
(3) Remove the screw ©
(4) Remove the 3 hooks © to remove the front panel.
. Clamp assembly
4.
Removing the mechanism assembly
(1) Remove the top cover .
(2) Remove the tray .
(3) Remove the connectors (P801, P802,P803) .
(4) Remove the 2 screws ® holding the clamp
assembly, then remove it.
{5) Remove the 3 screws. ® holding the mechanism
Mechanism assembly
assembly.
;
me
.
1-10(No. 20436)
Advertisement
