Kenwood TS-950SDX Instruction Manual page 59

6. Replace the bottom cover.
Note
Avoid pinching your fingers and the wiring
j harness when replacing the bottom cover.
|
6-3. VS-2 VOICE
INSTALLATION
1, Remove the top and bottom covers and open the
subchassis. Refer to Section 5-6-1 and 5-6-2.
| Caution
Open on a flat surface.
SYNTHESIZER
i
2. Plug the 8-pin connector onto the V8-2.
provided with the VS-2 for possible later use. |
They are not needed now.
j
4. Close the subchassis and replace the top and
bottom covers.
Note
Avoid pinching your fingers and
harness when replacing the cover.
the wiring
59