Kenwood TS-950SDX Instruction Manual page 55

5-6-2. Remove the Subchassis
1. Remove the screws as shown in the diagram.
2. Remove the jumpers on the rear panel.
3, Open in a clockwise direction,
Cautions
1. Open on a fiat surface.
2. Be careful not to damage the wiring.
3. Do not touch your finger or the cables between the
chassis when closing.
Turn VR2 while holding down the key in the CW mode
for the desired tone level.
Turn VRi to the desired tone volume.
VRI
[00000000]
5-6-5. Adjusting the Data Communications Modulation input Level
Set the input level for the desired modutation level with
VR5. Input is reduced by turning the control
counterclockwise, and increased by turning clockwise.
co
SESE
C=
55