Kenwood TS-950SDX Instruction Manual page 21

4-2. RECEIVER OPERATION
Different Main and Sub Receiver frequencies can be
received simultaneously. Reduce the audio of the
band you do not want to hear. You can turn off Sub
Receiver audio, if you do not need it, with the SUB
key.
4-2-1. Receiving
4. Connect the AC power cord and the antenna,
and then set the switches and controls as
follows:
(DPOWER switch : OFF (RB)
DATT switch ` : 0dB
@VOX/MAN, FULL/SEMI, MONI, DIM switches
: OUT (M)
@REC/SEND switch : REC (W)
G@THRU/AUTO switch : THRU (Ml)
®OFF/AT TUNE switch: OFF (W)
AGC switch : FAST
KEY SPEED control : Center
@PROCESSOR IN, OUT: Center
@PROC, NB1, NB2 switches
: OFF (W)
MIC, PWR controls : Fully counterclockwise
(ONB LEVEL controls : Fully counterclockwise
CAR control : Fully counterclockwise
DELAY control : Center
MONI, ANTI, GAIN controls
: Fully counterclockwise
SAL control : Fully counterclockwise
4&SUB AF gain control : Fully counterclockwise
PITCH control : Center
NOTCH, AF VBT switches
: OFF (W)
WAF gain control : Fully counterclockwise
RF gain control : Fully clockwise
"DIF VBT control : Fully clockwise
AF VBT control : Fully clockwise
SSB SLOPE TUNE
HIGH CUT control : Fully clockwise
LOW CUT control : Fully counterclockwise
. After presetting the controls as described above,
turn the transceivers POWER switch ON. The
display panel will indicate as shown below.
ruaAnnnan|
Pea
Gu
m
BE Bn
o soa 200300 «ao soo doo 70a Boo sog 1000
[aa a f i Tote rans rere i
Fenn
ce Ope
es artur
Lii
Note
jif the display is not as shown, reset the
microprocessor using the procedure provided
in Section 4-4-2.
. Turn the AF gain control clockwise until a signa!
or noise is heard.
. Rotate the TUNING knob and select a frequency
not currently used. If desired, adjust squelch as
follows: turn the SQL control clockwise until the
noise just disappears.
. Select the desired operating frequency. When a
signal is received, the S-meter will deflect.
. To turn off the transceiver, press the POWER
switch again,
21