Kenwood TS-950SDX Instruction Manual page 58

6. OPTIONAL ACCESSORIES
Be sure to unplug the AC power cable before
starting work.
6-1. DRU-2 DIGITAL RECORDING
UNIT INSTALLATION
1. Remove the top cover of the transceiver. Refer to
Section 5-6-1.
2, Using the tapping screw supplied with the DRU-
2, install the DRU-2 on the chassis.
3. Attach the three cables from the DRU-2 as
shown.
| Note
| Keep the cushions provided with the DRU-2 for
| later use. They are not needed now.
4. Replace the top cover.
58
6-2. OPTIONAL FILTER
INSTALLATION
[1] Install
1. Remove the bottom cover of the transceiver.
Refer to Section 5-6-1.
2. Remove the screws from where filters will be
installed as shown below. ===
3. Attach the filter(s) and secure it with the screws
you just removed. The filters are not polarized so
they may be placed in either direction.
[2]Rewriting Set Menu.
1, Turn onthe POWER while pressing the ENT key.
2. Amenu number is displayed.
3. Select the menu number that corresponds to the
filter(s) you are installing by rotation the
M.CH/VFO.CH knob.
4. Activate the filter with the UP/DOWN switches.
@ Option Setting Menu
Menu IF | Band Initial |
| number | | width l setting |
o 8.83(MHz} | "270(H2) | OFF |
02. 883MHz) sooHz) | ON
03 B.SS(MH2)1.8(kH2) | OFF
04 | 456(kHz) 250(Hz) OFF |
05 455(kHz) 500(Hz) | ON
| os | SUBII0.695MHz) | 500(Hz) ON