Kenwood TS-950SDX Instruction Manual page 50

4-12-2. Function Setting
Set menu No.9 to on for both TS-950SDX
transceiver(Please refer to Section 4-2-12.)
4-12-3. Data That Can Be Transmitted
Data that can be transmitted includes the following:
VFO frequency, VFO A/B, Filter settings, Meter
Indications, AIP ON / OFF, iMHz ON / OFF, FINE
ON/OFF.
4-12-4. Operation
E To write the same data to the quick memory
channels of both transceivers
1. Set menu No10 to OFF for the slave
transceiver(Please refer to Section 4-2-12).
2. Set the data, such as the frequency to be stored
in the master transceiver, and press the QUICK
MEMO M.IN key of the master transceiver. The
slave transceiver beeps, and the same data is
written to quick memory channeis 1 of both
transceivers.
3. When the QUICK MEMO M.IN key is pressed, the
latest data is written to channel 1. If there is
already data in channel 1, it is moved to channel
2.
For the quick memory recall method, see Section 4-
4-12,
E To rewrite the VFO frequency of the slave
transceiver directly
1. Set menu Noji0 to ON for the slave
transceiver(Please refer to Section 4-2-12}.
2. Set the data, such as the frequency to be stored
in the master transceiver, and press the QUICK
MEMO M.IN key of the master transceiver. The
data, such as the VFO frequency, in the slave
transceiver is replaced by the data in the master
transceiver. The same data is also written to quick
memory channel 1 of the master transceiver.
4-12-5. SPLIT Function Setting
Set menu No.9 to ON for the bath transceiver
{Please refer to Section 4-2-12).
(1} Data that can be transmitted
Data that can be transmitted includes the following:
VFO frequency and mode.
50
[2] Operation
E To write the data to the quick memory channels
of slave transceiver
1. Set menu No10 to OFF for the slave
transceiver(Please refer to Section 4-2-12).
2. Set the data, such as the frequency to be stored
in the master transceiver, and press the QUICK
MEMO M.IN key of the master transceiver, The
slave transceiver beeps, and the data is written to
quick memory channels 1 of slave transceiver.
The data is also written to quick memory channel
1 of the master transceiver.
3. When the QUICK MEMO M.IN key is pressed, the
latest data is written to channel 1. f there is
already data in channel 1, it is moved to channel
2.
For the quick memory recall method, see Section 4-
4-12.
E To rewrite the VFO frequency of the slave
transceiver directly
1. Set menu No10 to ON for the slave
transceiver(Please refer to Section 4-2-12).
2. Set the data, such as the frequency to be stored
in the master transceiver, and press the QUICK
MEMO M.IN key of the master transceiver. The
data, such as the TX VFO frequency, in the slave
transceiver is replaced by the data in the master
transceiver. The data is also written to quick
memory channel i of the master transceiver.