Kenwood TS-950SDX Instruction Manual page 16

® 1MHz UP/DOWN switch
Pressing the UP switch increases the frequency, and
pressing the DOWN switch decreases it.
® © &
[C7508 j
=E
SUB M/S
&
& TF-W (TX Frequency Watch) key
Use this key to activate/deactivate the TF-Watch
function.
& SUB Receiver key
Use this key to tum the Sub Receiver ON or OFF.
@& MIN key
Used to enter data into a memory channel.
@ M—VFO key
Used to transfer a frequency from memory
to the
VFO.
@ SCAN key
[Note
The Sub-receiver is operational in the SSB, CW
_and FSK modes only.
® M/S key
Use this key to specify which band (Main or Sub) is
controlled by the tuning controls, and filter, mode,
band keys, etc. When the Sub receiver is selected
the Sub indicator will light.
@ BAND/KEY key
Used to select an amateur radio frequency band.
When used in conjunction with the ENT key, the
keypad is used to directly enter a frequency.
When used in conjunction with the M.IN key,The
keypad is used to enter data into a memory
channel. When the M/S key is used to control the
Sub-receive this key is used to control the Sub-
receiver band.
&© CLR (Clear) key
Used when reentering memory channel data,
erasing a memory channel, quiting scan, or when
specifying the channels that will be skipped during
scan operations.
& ENT (Enter) key
Used to directly enter a frequency from the numeric key-
pad. This is also used to select either the Main or sub-
receiver depending upon M/S key selection.
16
79
TX VFO/SUB control
When
the Sub receiver
is OFF,
the transmit
frequency indicated in the TX frequency display can
be changed with this control.
Í Note f
This control
does not function
during
simplex `
operations.
When the Sub receiver is ON, the Sub receiver
frequency displayed can be changed with this
control, or the main tuning control if the M/S key
has been used to select the Sub-band.
® RIT/XIT control
RIT (Receiver Incremental Tuning)
First, cancel any previously programmed offset
using the CLEAR switch, then turn the RIT
switch ON. The RIT control shifts the receiver
frequency up to + 9.99 kHz. Use of the RIT
control will not affect the transmit frequency.
When the RIT switch is ON, the RIT indicator will
light, and the receive frequency can be
adjusted using the RIT control. Pressing the
CLEAR switch restores the RIT to zero. ,
Note :
When the RIT is ON the transmit frequency |
may be different from the receive frequency. ;
|For normal
operation,
leave
the RIT switch
OFF. it should be used only when necessary.
|