Table of Contents
Advertisement
Available languages
Available languages
Operation
Inserting/replacing the
tool
1. Push the desired bit (10-13) onto the
tool holder (1).
2. To remove it, pull the bit off from the
tool holder (1).
Set the direction of
rotation
You can toggle between right and left rota-
tion by pushing the direction of rotation
switch (8).
The direction changed may only be
performed in standstill mode!
1. Clockwise direction: Push the direction-
al switch (8) to the left up to the stop.
2. Counter-clockwise direction: Push the
directional switch (8) to the right up to
the stop.
Setting the no-load rotation
speed/impact rate/torque
•
Press the mode selection button (3) to
set the torque. You can read the current
level on the control panel.
Level Max. impact
rate
1
1100 rpm
2
2100 rpm
3
2600 rpm
4
3200 rpm
1. To insert the rechargeable battery (16)
2. To remove the battery (16) from the
Charging the battery
1. If necessary, remove the battery (16)
2. Slide the battery (16) into the charging
3. Plug the charger (15) into a socket.
4. Once charging is complete, disconnect
5. Remove the battery (16) from the
Switching on/off
Max. no-
1. Press the on/off switch (7). The device
load rotation
speed
1200 rpm
1700 rpm
2100 rpm
2700 rpm
2. To turn off, release the ON/OFF switch
Inserting/removing the
battery
into the device, push the battery along
the guides into the device. You will
hear it click into place.
device, press the release button (17) on
the battery and pull the battery out.
If warm, allow the battery to cool
before charging.
Charge the battery (16) when only
the red LED on the battery charge
level indicator (5) is illuminated.
from the machine.
slot of the charger (15).
the charger (15) from the mains
supply.
charger (15).
starts up in the set operating mode.
See Chapter "Setting the no-
load rotation speed/impact
rate/torque".
The LED work light (9) lights up during
operation.
(7).
GB
MT
25
Advertisement
Chapters
Table of Contents
