Pioneer VSX-D712 Operating Instructions Manual page 47

Setting up the receiver
We recommend setting this to 200Hz if your
S speakers are smaller bookshelf-type
speakers.
• Use 1} or _ to specify the crossover
frequency for your small speakers (100 Hz,
150 Hz or 200 Hz).
100Hz20-_HHz15OHz_
100Hz
Sends bass frequenc es below 100 Hz to
the subweofer (or L speakers).
150Hz
Sends bass frequenc es below 150 [qzto
the subweofer (or L speakers).
200Hz
Sends bass frequenc es below 200 [qzto
the subweofer (or L speakers).
_'_ I@ote
• If all speakers (front, center, and
surround) a_e set to L, the crossover
frequency can't be set because there are
no S speakers (_ appears in the
d splay),
LFE attenuator setting
• Default setting 0 dB
Dolby Dgtal and DTS audio sources include
ultra-low bass tones. Set the LFEattenuator
as necessary to prevent the ultra-low bass
tones from distorting the sound from the
speakers.
• Use 1} or _ to set the attenuation
level (0 dB, 10 dB or _ dB(_)).
Eo i ffZ'a
• When cois selected (_ appears in the
d splay), LFEcannot be heard.
Front left speaker distance setting
• Default setting 10 ft.
Sets the distanee flom the front left speaker to
the listening posit on.
• Use _ or _ to set the distance of the
front left speaker from the main listening
position (within the range of 0.5 ft. to 45
ft.).
Center speaker distance setting
• Default setting 10 ft.
The center speaker is normally placed directly
in the front of the listening room and closer to
the listening position than the front speakers.
This means that the sound from the center
speaker will be heard before the front
speakers, To prevent this, set the center
speaker distance setting to delay the sound
from the center speaker so that the sound
from the front and center speakers will be
heard at the same tme.
ER