Pioneer VSX-D712 Operating Instructions Manual page 13

5 minute guide
Using the Quick Setup
You can use the Quick Setup to get your
system up and running wth just a few button
presses. The receiver automatically makes
the necessary/settings after you have selected
your speaker setup, room sze and listen ng
position, ff you want to make more specific
settings, refer to Choos ng your rece vet setup
on page 44.
Use the front panel controls for the steps
below.
1 If the receiver is off, press
O STANDBY/ON to turn the power on.
The STANDBY ndicator goes out.
2 Press QUICK SETUP.
SW DET flashes in the d splay while the
rece vet checks your setup for a subwoofer.
SW YES or SW NO conf rms the subwoofer
check, then the d splay prompts you to select
your speaker setup.
3 Use the MULTI JOG dial to choose your
speaker setup.
When a subwoofer was detected in step 2, you
can cycle between the following choices:
2.1ch _ 3.1ch._1
7.1ch* 4.1ch
_'_ 6.1ch _ 5.1ch _
* VSX-D812 only
If a subwoofer wasn't detected in step 2, you
can cycle between the following choices:
2.0ch _ 3.0ch
7.0ch* 4.0ch
6.Och m 5.0ch
* VSX-D812 only
• Check the table below to find the speaker
setup that corresponds with your system.
Front Center Surround Surr_m Sdb
speakers Sl_br speakersBad(Sp. Noof_
z.o d_ ,/
Z.lch ¢ ¢
s.och ¢ -/
S.Ich ¢ ¢ ¢
4.o ch '_ ¢
4.1ch ¢ ¢ ¢
s.och ¢ ¢ ¢
s.1ch ¢ _/ ¢
6.0 ¢h _/ _/ _/ (lspeakei
6.1 ch _/ _/ _/ (lspeakei _/
7.0ch* _ _ _ _spea_
7.1ch* ¢ ¢ ¢ _sl_l_ -7
* VSX-D812 only
4 Press ENTER.
5 Use the MULTI JOG dial to choose your
room size.
Depending on the distance of your speakers
from the listening pos tion. choose between
small, med um, or large (S, M or L), M being
an average-sized room.
6 Press ENTER.
En