Pioneer VSX-D712 Operating Instructions Manual page 12

D _ 5 minute guide j'_,
• If you are using only one surround back speaker, connect the positive wire to the right
channel (+) terminal, and the negative whe to the left channel (-) terminal (shown below).
• If you select subwoofer (SBSW) in the Surround back speaker setting on page 46 you can
hook up a subwoofer instead of speakere to the surround back speaker terminals. Connect
the wires just as above (and as shown below), connecting the posit ve wire to the dght
channel (+) terminal, and the negative whe to the left channel (-) terminal.
Surround back
speaker (or
I I
subwoofer) _
VSX-D812
4 Plug in the receiver and switch it on, followed by your DVD player, your subwoofer
and the TV.
Make sure you've set the video input on your TVto this receiver. Check the manual that came
with theTV if you don't know how to do this,
Also make sure that DVD/LD is showing in the rece veCs d splay, ndicating that the DVD nput
is selected. If it isn't, press DVD/LD on the remote contrel to set the receiver to the DVD nput.
5 Press QUICK SETUP on the front panel to specify your speaker setup, room size and
listening position.
Use the MULTI JOG dial to select and ENTER to confirm you r selection. See Using the Quick
Setup on page 13 if you're unsure about the settings,
6 Play a DVD, and adjust the volume to your liking.
There are several other sound options you can select, See ]ntreduction to Sound Modes on
page 36 for more on this. See also Choos ng your receiver setup on page 44 for more setup
options.
G Note
• Depending on your DVD player or source discs, you may only get digital 2 channel stereo
and analog sound, In this case, the I stening mode must be set to STANDARD (it should
already be set---see Listening to multi-channel playback on page 38 f you need to do this) if
you want multi-channel surreund sound.
ill L
F