Table of Contents
Advertisement
8.5 - PASSIVE ARMING
Engine block passive arming, if enabled, automatically activates the double
ENGINE LOCK 60 sec. after the engine has been switched OFF or 60 sec.
after the alarm has been disabled (if engine is not switched back on).
The status LED will flash quickly to confirm activation.
If a door is opened during the passive arming countdown, the countdown will
stop and start over again when the door is closed. The LED will be ON steady.
8.6 - LOCK TIME
The lock time is factory preset at 0,5 seconds but it can be adjusted to 6
seconds during the programming phase.
If the comfort function has been enabled, keep the lock time set to 0,5".
Setting it at 6" will cause the windows to open when the alarm is disarmed.
8.7 - COMFORT CONTROL
The comfort control feature automatically closes all windows when the alarm is armed.
If this function is enabled, the power window motor will receive a 25" command
to roll-up all windows when the alarm is armed.
8.8 - CDL DOUBLE PULSE UNLOCK
This function, if enabled, provides a double pulse unlock (approx. 0,5 seconds
each) upon disarming the system.
With the two-stage unlock, the first pulse unlocks the driver door and the
second pulse the remaining doors.
This function is only active if the lock/unlock time is set at 0,5". Setting 6" will
automatically disable double pulse unlock.
9.0 - ULTRASONIC VOLUMETRIC SENSOR ADJUSTMENT
The volumetric sensor provides interior protection. To adjust the sensitivity
level according to the area to the area that needs to be covered proceed as
follows:
- Arm the system excluding the sensors (see relative paragraph).
- Adjust the trimmer at a medium setting.
- After the arming delay, introduce an object in the cabin through the window
and move it around; the status LED will turn ON to signal a presence.
- If sensitivity level is too high or low, readjust the trimmer and repeat the above
procedure.
PAG
E 2
1
10.0 - LEARNING NEW CONTROL DEVICES
To carry out the operation successfully, make sure the required electrical
connections (door /bonnet switch and ignition) have been completed.
Storing memory is for 8 devices (remote controls, electronic keys or magnetic
contacts (protection devices). If an extra device is added, the LED will start
flashing quickly to indicate the memory is full. To activate the learning
procedure, proceed as follows:
1)
With the alarm system disarmed, open the driver door and bonnet and leave
them open.
Do not close the bonnet otherwise all previously programmed
devices will be erased.
2)
Turn ignition key ON.
3)
Press a button on an already learned remote or insert an already learned
electronic key in its receptacle.
4)
Two slow flashes of the turn indicators will confirm the system has entered in
learn mode.
5)
According to the device to be learned: press remote control button 1 OR
introduce the electronic key in its receptacle OR make the magnetic contact
transmit (bring contact and magnet close together and then move apart).
6)
The status LED will flash once to confirm learning of a new device.
7)
Repeat the procedure from step 5 to program any other device.
8)
Turn ignition key OFF.
9)
A long flash of the turn indicators will confirm the end of the procedure.
11.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) DIRECTIVE
The present device does not fall within the scope of Directive 2002/96/EC on Waste Electrical
and Electronic Equipment (WEEE) as specified in art. 2.1 of L.D. no. 151 of 25/07/2005.
PAG
E 3
1
Advertisement
Table of Contents
