Memory Modules - HP mt45 Maintenance And Service Manual

Memory modules

NOTE: Primary and expansion memory is installed in a side-by-side configuration in the bottom of the
computer.
If only one memory module is installed, it must be installed in the socket labeled 1.
Table 5-3 Memory module descriptions and part numbers
Description
4 GB (DDR-2666)
IMPORTANT:
at www.hp.com.
Before removing the memory module, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the memory module:
1. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module.
(The edge of the module opposite the slot rises away from the computer.)
2. Remove the memory module (2) by pulling the module away from the slot at an angle.
IMPORTANT:
NOTE:
module and the socket labeled 1 houses the primary memory module. The removal procedure is the
same for both memory sockets.
Reverse this procedure to install a memory module.
Before adding new memory, make sure you update the computer to the latest BIOS, available
Bottom cover on page
Do not remove memory shielding from the system board when replacing memory.
The computer uses two memory sockets. The socket labeled 2 houses the expansion memory
(Preparation for disassembly on page
32).
Battery on page
Spare part number
L10598-850
32).
44).
Component replacement procedures 35