Energy zeroCO2 XL Operation Manual page 66

•
Remove the control module from the holder and place it in the predetermined place.
•
Install the new control module (BMS) and reconnect all cables. Refer to chapter
"5.4 BMS control module and battery battery module installation in zeroCO2 -
BESS 125K" at page 52.
•
Perform the system turn on procedure. Refer to the chapter "6.1 System turn ON"
at page 62.
Fig. 7.2 - BMS control module replacement
Fig. 7.3 - BMS control module replacement
zeroCO XL
2
Maintenance - 67