Running A Transport Cleaning Sheet; Final Cleaning Steps - Kodak i4 50 Series User Manual

Running a transport
cleaning sheet

Final cleaning steps

A-61837 September 2016
Lower imaging guide
8. Turn the screw to the left on each end of the lower imaging guide and
remove it from its position. Carefully set the imaging guide aside.
9. Carefully vacuum the area between the LEDs.
IMPORTANT: Avoid contact with the LEDs, as contact could cause
damage. Do not insert any objects into the area between the
upper LED strips, as you may damage the reflective mirrors
in the scan module on the illumination system.
10. Clean both the top and bottom of the lower imaging guide thoroughly with a
Staticide wipe or a "Step 1" Brillianize Detailer wipe.
11. Wipe the imaging guide again with an almost-dry Staticide wipe or a "Step
2" Brillianize Detailer wipe to remove any streaks.
12. Reinstall the lower imaging guide.
13. Close the scanner cover.
14. When finished with all cleaning procedures, turn on the scanner.
The transport should be cleaned with a Transport Cleaning Sheet fed several
times.
1. Remove the wrapping from the Transport Cleaning Sheet.
2. Adjust the side guides to the widest position.
3. Place the transport cleaning sheet in the center of the input elevator in
landscape orientation with the adhesive side up.
4. Use the Count Only option from the Diagnostics menu on the Operator
Control Panel to run the sheet through the scanner.
5. Remove the transport cleaning sheet from the output tray and place it in
the center of the input elevator in landscape orientation with the adhesive
side down and rescan.
NOTE: When the transport sheet gets dirty and/or loses its tackiness, discard
it and use a new one.
When you have finished running the transport cleaning sheet:
1. Power down the scanner.
2. Open the scanner cover.
3. Wipe the exposed side of the upper and lower imaging guides with a lint-
free cloth.
4. Close the scanner cover and scan a test image to ensure image quality.
59