Clean In This Order; Running A Transport Cleaning Sheet - Kodak S2000 Series User Manual

Clean in this order

Running a transport cleaning sheet

A-61931 April 2021
1. Before cleaning, disconnect the electrical power.
2. Use a transport cleaning sheet several times to remove residue
from the rollers. This cleaning technique is simpler for you and helps
preserve the rollers. See "Running a transport cleaning sheet".
3. If the rollers do not come clean with the transport cleaning sheet,
then clean them with roller cleaning pads. Refer to "Cleaning the
separation roller" and "Cleaning the feed rollers".
4. When the rollers are clean, clean the imaging area. Refer to
"Cleaning the imaging area".
5. Wash your hands with soap and water after performing
maintenance procedures.
6. Go to Maintenance on your scanner screen display and choose
Clean > Reset. See "Scanner meters" on page 39.
1. Remove the wrapping from the Transport Cleaning Sheet.
2. Adjust the side guides to fit the cleaning sheet.
3. Place a transport cleaning sheet in the input tray (adhesive side up,
toward you) in portrait orientation.
4. Using your scanning application, scan the transport cleaning sheet.
5. After the transport cleaning sheet is scanned, turn it over (adhesive
side down, toward the input tray) and scan it again.
6. Open the scanner cover and wipe the imaging area with a lint-free
cloth.
7. Close the scanner cover.
8. Scan a few pages. Check that ink or toner from the rollers is not
visible on scanned pages or on images.
9. If necessary, repeat this procedure.
NOTE: When a transport cleaning sheet gets very dirty, discard it and
use a new one. If the sheet is not dirty, put it back into its
wrapping to save for re-use.
4 Maintenance
41