Using Auto-Set; Jog Mode - Miller Millermatic 190 Owner's Manual

6-2. Using Auto-Set

3
1 Wire Speed/Wire Diameter Control
To turn Auto-Set on, turn the Wire Speed/
Wire Diameter control knob to the desired
wire diameter setting.

6-3. Jog Mode

If gun trigger is held for longer than 3 seconds without initiating a weld arc, unit will enter Jog mode and disable weld output.
S Jog mode is used to quickly feed wire through the wire drive assembly and MIG gun.
S While in Jog mode, wire feed speed is adjustable using the Wire Speed/Wire Diameter control knob.
S To exit Jog mode, release gun trigger.
.
A complete Parts List is available on-line at www.MillerWelds.com
2 Auto-Set Light
The Auto-Set light illuminates indicating
Auto-Set is on.
1
2
3 Voltage/Material Thickness Control
Adjust the Voltage/Material Thickness
control knob to the desired steel material
thickness to weld.
.
There is no adjustment within the
material thickness band.
OM-264761 Page 25
274602-A