Rack It - Juniper EX2300 Quick Start Manual

NOTE: We no longer include a DB-9 to RJ-45 cable or a DB-9 to RJ-45 adapter with a CAT5E
copper cable as part of the device package. If you require a console cable, you can order it
separately with the part number JNP-CBL-RJ45-DB9 (DB-9 to RJ-45 adapter with a CAT5E
copper cable)

Rack It!

Here's how to install the EX2300 switch in a two-post rack:
1. Review the General Safety Guidelines and
2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end to a site ESD point.
3. Attach the mounting brackets to the sides of the EX2300 switch using the eight mounting screws
and a screwdriver.
You'll notice there are three locations on the side panel where you can attach the mounting brackets:
front, center, and rear. Attach the mounting brackets to the location that best suits where you want
the EX2300 switch to sit in the rack.
4. Lift the EX2300 switch and position it in the rack. Line up the bottom hole in each mounting bracket
with a hole in each rack rail, making sure the EX2300 switch is level.
Warnings.
4