Step 2: Up And Running - Juniper EX2300 Quick Start Manual

b. Insert the L-shaped ends into the holes in the bracket above and below the AC power socket.
The power cord retainer clip extends out of the chassis by 3 in. (7.62 cm).
2. Plug in the power cord to the AC power socket on the switch.
3. Push the power cord into the slot in the adjustment nut for the retainer clip.
4. Turn the nut clockwise until it's snug against the base of the coupler. The slot in the coupler should
be 90 degrees from the power supply socket.
5. If the AC power outlet has a power switch, turn it off.
6. Plug in the power cord to the AC power outlet.
7. If the AC power outlet has a power switch, turn it on.
8. Verify that the AC OK LED above the power inlet is steadily lit.
The EX2300 switch powers up as soon you connect it to the AC power source. When the SYS LED on
the front panel is steadily green, the switch is ready to use.

Step 2: Up and Running

IN THIS SECTION
Plug and Play | 7
Customize the Basic Configuration Using the CLI | 7
Now that the EX2300 switch is powered on, let's do some initial configuration to get the switch up and
running on your network. It's simple to provision and manage the EX2300 switch and other devices on
your network. Choose the configuration tool that's right for you:
• Juniper Mist. To use Mist, you'll need an account on the Juniper Mist Cloud platform. See
of Connecting Mist Access Points and Juniper EX Series Switches.
6
Overview