Juniper EX2300 Quick Start Manual page 11

6. Delete the ZTP configuration. Factory default configurations can vary over different releases. You
may see a message that the statement does not exist. Don't worry, it's safe to proceed.
{master:0}[edit]
root# delete chassis auto-image-upgrade
7. Add a password to the root administration user account. Enter a plain-text password, an encrypted
password, or an SSH public key string. In this example, we show you how to enter a plain-text
password.
{master:0}[edit]
root# set system root-authentication plain-text-password
password
New password:
Retype new password:
8. Activate the current configuration to stop ZTP messages on the console.
{master:0}[edit]
root# commit
configuration check succeeds
commit complete
9. Configure the hostname.
{master:0}[edit]
root# set system host-name
10. Configure the IP address and prefix length for the management interface on the switch. As part of
this step, you remove the factory default DHCP setting for the management interface.
{master:0}[edit]
root# delete interfaces vme unit 0 family inet dhcp
root# set interfaces vme unit 0 family inet address
NOTE: The management port vme (labeled MGMT) is on the front panel of the EX2300
switch.
password
name
address/prefix-length
9