Table of Contents
Advertisement
MIC Series 550
16.7
Remapping Aux Commands (Pelco Protocol, firmware version
2.10 and higher)
The camera has a Pelco submenu called AUX Setup. Pelco controller keyboards (for protocols
D and P) support 8 different auxiliaries (AUX On/OFF commands), but do not define what
function each should perform. In the AUX Setup submenu, some common commands from
these keyboards can be "remapped" to one of the 8 AUX commands:
The common commands for MIC analog cameras are:
Wiper
WASH WIPE
Setup Menu
Backlight Comp.
Additionally for the MIC550, the following commands are available:
IR Illuminator
Gain Control
Night Mode
Night Mode Auto
For the MIC612, an additional AUX command is "Thermal." When "ON," the "Switched output"
is the thermal camera video. When "OFF," the "Switched output" is the optical camera video.
By default, the Aux numbers of the functions are mapped as follows in MIC550:
1
2
5
6
7
8
To change a mapping, select the auxiliary number from the 8 available, press right to select,
and then scroll through the available functions using up and down control inputs.
For example, to remap the Aux command for the wiper in the MIC550 camera to match the
number of the Aux command used in an existing installation, follow these steps:
1. Select option one ("WASH WIPE" by default). Set the value to "Not Set."
2. Select option two ("Alarm Output 2" by default). Set the value to "WASH WIPE." The MIC550
camera will now activate the wash/wipe function in response to the Aux 2 command.
16.8
Using the Wiper/Washer (Pelco Protocol)
To activate the washer/wiper in Pelco protocol, follow these steps:
Bosch Security Systems, Inc.
AUX Command
Enters the Setup Menu using an
AUX command, instead of Preset
95.
AUX Command
WASH WIPE
Alarm Output 2
Not Set
Not Set
Not Set
Not Set
Function when ON
Function when ON
Operation Manual
Common User Commands | en
Function when OFF
Function when OFF
2014.11 | 3.2 | F.01U.239.454
71
Advertisement
Table of Contents
