Advertisement
4.
On the idler assembly side, align the
adjuster-arm rod of the HOC bracket with the
adjuster collar on the idler assembly and secure
it with a shoulder bolt as shown in
torque the shoulder bolt to 20 to 26 N⋅m (15 to
19 ft-lb).
Figure 13
1. Shoulder bolt
2. Adjuster-arm rod
5.
Tighten the carriage bolts and locknuts securing
the HOC bracket assemblies to the side plates
(Figure
14).
Figure
13;
g346925
3. Adjuster collar
4. Idler assembly
1. Adjusting bolt
2. Locknut
3. Carriage bolt and flange
locknut (3/8 with 5/8 inch
hex)
6.
Tighten the locknut on the HOC adjuster bolt,
then back off the locknut 1/2 turn
7.
Center the front roller between the HOC bracket
assemblies and lock it in place with the cap
screws and flange nuts
8
Installing the Groomer
Drive Cap
Parts needed for this procedure:
1
Cap
Procedure
Only for Universal Groomer assemblies with no
rear roller brush kit installed:
1.
Apply medium-strength cylindrical bonding
retaining compound (such as Green Loctite
609®) around the snap ring groove and the
outer diameter surface
9
Figure 14
4. Flange nut
5. Capscrew
(Figure
(Figure
14).
(Figure
15).
g346926
14).
Advertisement
