Advertisement
Figure 20
1. Brush
5.
Loosely wrap the straps, as shown in
18, around the groomer reel shaft and brushes,
inserting the straps in the grooves in the brushes
Figure
20.
Position the straps on the brushes using the
following table:
Reel Size
18 inch
22 inch
27 inch
Important:
You must wrap the straps around
the groomer blade and brush assembly in the
primary rotating direction.
the straps installed for forward rotation.
Note:
If the broomer brushes are not
seated properly in the blade slots, loosen the
groomer-blade retaining nuts on each end of the
groomer shaft, position the broomer brushes
properly in the blade slots, and tighten the
groomer-blade retaining nuts
6.
Tighten the groomer blade retaining nuts; torque
them to 45.2 N∙m (400 in-lb).
7.
While pushing a screwdriver against the strap
buckle, grasp each strap with a locking pliers
and pull the straps tight until they lock into the
brush grooves
(Figure
8.
Trim the strap so that it is 6 mm (1/4 inch) from
the buckle and fold the excess strap over the
buckle.
g032402
2. Blade
Figure
Strap Spacing
Position the straps between
blades 2 and 3; 11 and 12; 21
and 22; and 30 and 31
Position the straps between
blades 2 and 3; 14 and 15; 26
and 27; and 38 and 39
Position the straps between
blades 2 and 3; 23 and 24 or
24 and 25; 35 and 36; and 45
and 46
Figure 19
shows
(Figure
18).
18).
12
Advertisement
