Advertisement
1. Drive-stub shaft
2. Groomer assembly
3. Jam nut (4)
3.
Secure the groomer to the machine as shown in
Figure 17
and snug the bolts.
4.
To prevent binding, set the height of cut and
height of groom, then loosen the bolts.
Note:
To set the height of cut refer to your
cutting unit Operator's Manual; refer to
the Groomer Height (page 16)
height of groom.
5.
Torque the bolts to 5 to 7 N∙m (46 to 60 in-lb).
6.
Check and adjust height of cut and height of
groom as necessary.
Installing the Broomer Kit
Part Number
132-7115
18-inch Broomer Kit
132-7125
22-inch Broomer Kit
133-8222
27-inch Broomer Kit
1.
Obtain an optional broomer kit for groomer
blade cartridges appropriate for your needs and
cutting unit; refer to the table above.
2.
Loosen the groomer blade-retaining nuts on
each end of the groomer shaft
Figure 17
4. Shaft clamp (4)
5. Bolt (4) Torque to 5 to 7
N∙m (46 to 60 in-lb)
for adjusting the
Broomer Kit
(Figure
g240752
1. Strap buckle
2. Retaining nut
3.
From 1 side of the groomer reel, slide a brush
into each groove around the full length of the
groomer reel
Adjusting
1. Strap
2. Brush
4.
Verify that the brushes are seated in the groomer
blade slots
18).
11
Figure 18
3. Strap
4. Brush
(Figure
19).
Figure 19
22 inch groomer shown
3. Toward rear of machine
(Figure 18
and
Figure
g032403
g227786
20).
Advertisement
