Advertisement
11
Installing the Angled Fitting
For Reelmaster 3550 and 3555
Machines—#1 Front, Center
Cutting Location and Kit Model
145-5605 Only
Parts needed for this procedure:
Hydraulic fitting—45° (Part No. 340–101; sold
1
separately)
Procedure
Important:
For Reelmaster 3550 and 3555
machines—#1 front, center cutting location and
kit Model 145-5605 only; order 45° hydraulic fitting
(Part No. 340–101) and follow the procedure
below.
1.
Remove the hydraulic hose from the hydraulic
fitting on the motor.
2.
Remove the 2 O-rings on the new 45° fitting,
lubricate them with grease, and install them on
the fitting.
3.
Remove the existing fitting.
4.
Install the new 45° fitting, positioning the fitting
with the angle of the fitting as shown in
22. Torque the fitting to 47 to 58 N∙m (35 to 43
ft-lb).
1. Cutting unit motor
Figure
2. 45° fitting
5.
Connect the hydraulic hose into the new fitting;
torque the hose fitting to 40 to 64 N∙m (37 to 47
ft-lb).
Note:
that the hose does not contact the groomer
adjuster.
14
Figure 22
3. Groomer adjuster
Ensure that the fitting is positioned so
g365834
Advertisement
