Advertisement
Right side groomer box shown
1. Air-vent plug
2. Fill plug
Removing the Groomer
Drive Box
Note:
Retain all removed parts for later installation
unless otherwise stated.
Important:
If you have any issues removing the
groomer drive box, refer to your traction unit
Service Manual or contact your authorized Toro
distributor.
1.
Remove the cap from the groomer.
2.
Remove the clamp bolts connecting the groomer
to the drive box
(Figure
3.
Remove the shoulder bolt and hardened washer
connecting the groomer drive box to the adjuster
arm
(Figure
30).
Figure 29
3. Drain plug
17).
g346930
1. Shoulder bolt
2. Hardened washer
4.
Restrain the reel for removal; refer to
the Reel for Removing Threaded Inserts (page
21).
5.
Install the reinforcement screw (Part No.
1-803022—sold separately) to the internal
threads of the groomer drive hex head and
torque to 13.5 N⋅m (120 in-lb) as shown in
Figure
30.
6.
Remove the groomer drive box from the cutting
reel by turning the groomer drive hex-head
(Figure
30).
Important:
installed on the right side of a cutting
unit, turn the groomer drive hex-head
counter-clockwise (right-hand thread) to
remove the drive-box shaft from cutting unit.
Important:
installed on the left side of a cutting unit,
turn the groomer drive hex-head clockwise
(left-hand thread) to remove drive-box shaft
from cutting unit
Important:
with heavy wall.
20
Figure 30
3. Groomer drive hex-head
4. Reinforcement screw
If the groomer drive box is
If the groomer drive box is
You must use a 6-point socket
g346932
Restraining
Advertisement
