Connecting The Camera - Swann SW331-PR6 Operating Instructions Manual

Connecting the Camera

1
1. After running the camera cable through the mounting arm/bracket,
attach to the main plug on the camera circuit board (see opposite).
2. Connect the BNC connector and power connectors to an extension
cable.
3. Connect the purple and white wires to the RS485 plug, and insert
the RS485 plug into the RS485 port on the rear of the controller (see
opposite).
4. Attach the BNC plug on the end of the extension cable to a BNC input
on your TV, VCR or DVR (as applicable). If your monitor/recorder does
not have a BNC connection, then use a BNC to RCA adaptor.
5. Connect the power connector on the end of the extension cable to
the DC plug of a power adaptor (DC 12V).
6. Attach the power connector on the rear of the PTZ controller to a
power supply (DC 12V).
7. Plug the DC 12V power adaptors into mains power.
8 8 8
2
3
6
4
5
7