Problems Related To Quality / Print Results; Paper Does Not Feed From The Paper Tray; The Image On Paper Is Skewed; The Automatic Document Feeder Does Not Operate - Sharp MX-B402 Operation Manual

Problem
The paper misfeeds.
Paper does not feed
from the paper tray.
The image on paper is
skewed.
The automatic
document feeder does
not operate.

PROBLEMS RELATED TO QUALITY / PRINT RESULTS

Problem
Lines appear in the
scanned image.
Point to check
Has the correct paper size been set?
Did you add paper to the bypass tray?
Is the paper loaded correctly in the
paper tray?
In the Paper Tray Settings of the system
settings, are restrictions placed on the
trays that can be used in each mode
(copy, print, fax, Internet fax, and
document filing)?
Is too much paper loaded in the bypass
tray?
Are the bypass tray guides adjusted to
the width of the paper?
Are the original guides adjusted to the
width of the paper?
Have functions been disabled by the
administrator?
Point to check
Are the scanning areas of the document
glass or automatic document feeder
dirty?
Is the paper feed roller or the bypass
feed roller dirty?
If you are using a special size, be sure to specify the
paper size.
If the size of paper loaded in a tray was changed, be
sure to check the paper size setting.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings"
When adding paper, remove any paper remaining in
the bypass tray, combine it with the paper to be
added, and reload as a single stack. If paper is added
without removing the remaining paper, a misfeed may
result.
Set the guides to the size of the paper. Make sure the
height of the paper does not exceed the indicator line.
Check the Paper Tray Settings and see if
checkmarks appear in the checkboxes of each
mode (Feeding Approved Job). Functions without a
checkmark cannot be used for printing using that tray.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings" > "Change" >
Do not load more than the maximum number of
sheets.
The maximum number of sheets varies depending on
the paper type setting. For more information, see
"SPECIFICATIONS" in the Start Guide.
Adjust the bypass tray guides to the width of the
paper.
Adjust the original guides to the width of the paper.
Check with your administrator.
Some functions may have been disabled in the system
settings (administrator).
Clean the scanning areas of the document glass or
automatic document feeder.
☞
Start Guide
Clean the surface of the paper feed roller or the
bypass feed roller.
☞
Start Guide
8-46
TROUBLESHOOTING
Solution
(Each mode)
Solution
Contents