The Finisher Does Not Operate; Stapling Does Not Take Place; The Stapling Position Is Not Correct; Output Does Not Collect Neatly In The Output Tray Of The Finisher - Sharp MX-B402 Operation Manual

Problem
The finisher does not
operate.
Stapling does not take
place.
The stapling position
is not correct.
Output does not
collect neatly in the
output tray of the
finisher.
Stapled output does
not collect neatly.
Point to check
Does a message appear indicating that
you need to remove paper from the
stapler compiler?
Does the following message appear in
the touch panel?
"Call for service. Code:xx-xx. Finisher
trouble."
*Letters and numbers appear in xx-xx.
Does a message appear instructing you
to check the staple unit?
Does a message appear instructing you
to add staples?
Is a different width of paper mixed in?
Are there more sheets than can be
stapled at once?
Is a paper size that cannot be stapled
included in the print job?
Is the paper type setting of the tray
selected in the printer driver set to a
paper type that cannot be stapled?
Have functions been disabled by the
administrator?
Is the stapling position set correctly?
Is the paper curled?
Is the paper curled?
Remove all remaining paper from the stapler compiler.
Check the connection cable. Remove and then firmly
reinsert the connection cable, and restart the machine.
Remove jammed staples.
☞
"REMOVING STAPLE
Replace the staple cartridge. Do not forget to replace
the staple case.
☞
"REMOVING STAPLE
To perform mixed size stapling, use paper of the
same width.
Stapling is not possible when paper of different widths
are mixed together. When copying, select [Mixed Size
Original] in the special modes.
For the maximum number of sheets that can be
stapled, see "SPECIFICATIONS" in the Start Guide.
For the paper sizes that can be stapled, see
"SPECIFICATIONS" in the Start Guide.
Check the paper type settings in the machine and select
a tray that has paper that can be used for stapling*.
Click the [Tray Status] button in "Paper Selection" on
the [Paper] tab of the printer properties window and
check the paper type setting of each tray.
* Stapling is not possible on labels, transparency film, or
envelopes. In addition, if "Disable Staple" is selected in
the user type, stapling will not be possible.
Check with your administrator.
Some functions may have been disabled in the system
settings (administrator).
Check the stapling position setting.
☞
2. COPIER "OUTPUT" (page 2-35)
It may help to turn the paper over in the paper tray.
It may help to turn the paper over in the paper tray.
8-49
TROUBLESHOOTING
Solution
JAMS" (page 8-15)
JAMS" (page 8-15)
Contents