Device Control; Other Settings; Auto Paper Selection Setting - Sharp MX-B402 Operation Manual

Device Control

These settings control devices installed on the machine. Touch the [Device Control] key to configure the settings.

Other Settings

AB/Inch Type Setting
The numbers and units of the default settings and input
ranges that appear in the setting screens can be
switched between inches and AB sizes.
Default Original Size Settings
Specify this setting when a particular original size is
frequently used. The setting will appear in the [Original] key.
Specifying this setting allows the original size setting to
be omitted.
Mode
1
Copy None* , A5, B5, A4,
216mm x 330mm (8-1/2" x 13"),
8-1/2" x 13-2/5" (216mm x 340mm),
216mm x 343mm (8-1/2" x 13-1/2"),
8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2",
16K, Check Size*
1
Image Send None* , A5, B5, A4,
216mm x 330mm (8-1/2" x 13"),
8-1/2" x 13-2/5" (216mm x 340mm),
216mm x 343mm (8-1/2" x 13-1/2"),
8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2",
16K, Check Size*
1
Scan to HDD None* , A5, B5, A4,
216mm x 330mm (8-1/2" x 13"),
8-1/2" x 13-2/5" (216mm x 340mm),
216mm x 343mm (8-1/2" x 13-1/2"),
8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2",
16K, Check Size*
1 When [None] is selected, the original size does not
*
appear and must always be set manually.
2
* "Check Size" and "Card Size" are only for MX-B402SC.
Setting of Default Original Exit Place
MX-B402SC Only
When the automatic document feeder is used, the
original's* default output destination can be set to the
upper exit or the heavy exit.
* Except when "Size Input" or "Card Size" is selected for
the original size.
Settings
2 2
, Card Size*
2
, Long Size
2 2
, Card Size* , Long Size
7-69
Original Feeding Mode
The following original feeding modes can be set to
operate by default in copy, Scan to HDD, and image
send modes. When a mode is frequently used, this
saves you from having to select the mode in the special
modes each time you need to use it.
• Mixed Size Original (Same Width (Copy mode only))
• Slow Scan Mode
• Blank Page Skip (image send* when using
MX-B402SC)
* Excluding fax mode and Internet fax mode.

Auto Paper Selection Setting

The paper types* that the Auto Paper Selection function will
select can be specified. Select one of the following settings:
• Plain Paper
• Plain and Recycle Paper
• Recycle Paper
The Auto Paper Selection function will not select any
paper types other than the paper types specified with
this setting.
* The paper type set for each paper tray using
Tray Settings" (page 7-14) in the system settings
(general).
Detect Standard in Auto Color
Mode
When the color mode is set to auto in image send mode,
the discrimination point for detecting whether originals
are color or black and white can be set to one of 5 levels.
To make it easier to detect a black and white original,
adjust the setting toward [(Closer B/W)]. To make it
easier to detect a color original, adjust the setting toward
[(Closer color)].
SYSTEM SETTINGS
"Paper
Contents