Device Control; Other Settings - Sharp mxb381 Operation Manual

Device Control

These settings control devices installed on the machine. Touch the [Device Control] key to configure the settings.

Other Settings

AB/Inch Type Setting
The numbers and units of the default settings and input
ranges that appear in the setting screens can be
switched between inches and AB sizes.
Default Original Size Settings
Specify this setting when a particular original size is
frequently used. The setting will appear in the [Original]
key.
Specifying this setting allows the original size setting to
be omitted.
Mode
Copy None, A5, B5, A4,
216mm x 330mm (8-1/2" x 13"),
8-1/2" x 13-2/5" (216mm x 340mm),
216mm x 343mm (8-1/2" x 13-1/2"),
8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2",
16K
Image Send None, A5, B5, A4,
216mm x 330mm (8-1/2" x 13"),
8-1/2" x 13-2/5" (216mm x 340mm),
216mm x 343mm (8-1/2" x 13-1/2"),
8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2",
16K, Long Size
Scan to HDD None, A5, B5, A4,
216mm x 330mm (8-1/2" x 13"),
8-1/2" x 13-2/5" (216mm x 340mm),
216mm x 343mm (8-1/2" x 13-1/2"),
8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2",
16K, Long Size
When [None] is selected, the original size does not
appear and must always be set manually.
Settings
7-61
Original Feeding Mode
The following original feeding modes can be set to
operate by default in copy, Scan to HDD, and image
send modes. When a mode is frequently used, this
saves you from having to select the mode in the special
modes each time you need to use it.
• Mixed Size Original (Same Width (Copy mode only))
• Slow Scan Mode
Auto Paper Selection Setting
The paper types* that the Auto Paper Selection function will
select can be specified. Select one of the following settings:
• Plain Paper
• Plain and Recycle Paper
• Recycle Paper
The Auto Paper Selection function will not select any
paper types other than the paper types specified with
this setting.
* The paper type set for each paper tray using
Tray Settings" (page 7-13) in the system settings
(general).
Detect Standard in Auto Colour
Mode
When the colour mode is set to auto in image send
mode, the discrimination point for detecting whether
originals are colour or black and white can be set to one
of 5 levels. To make it easier to detect a black and white
original, adjust the setting toward [(Closer B/W)]. To
make it easier to detect a colour original, adjust the
setting toward [(Closer colour)].
SYSTEM SETTINGS
"Paper
Contents