Table of Contents
Advertisement
Message
Cause
No loop signal
The power supply or low-voltage cable are
not connected.
The power supply or low-voltage cable are
damaged or not connected.
The boundary wire is not connected to the
charging station.
The boundary wire is damaged.
The product has tried to start but it is not in
the charging station and
bled.
A section of the boundary wire is across the
other section of boundary wire to and from
an island.
Problem with the pairing between the product
and the charging station.
Interference from metal objects such as fen-
ces, reinforcement steel or buried cables
nearby.
The product is too far from the boundary
wire.
Mower tilted
The product is tilted more than the maximum
angle.
34 - Troubleshooting
Action
If the LED status indicator on the charging
station is not lit, it shows that there is no
power. Examine the power outlet connection
and the residual-current device. Make sure
that the low-voltage cable is connected to the
charging station.
Replace the power supply or low-voltage ca-
ble.
Connect the boundary wire to the charging
station. Replace the connectors if damaged.
Refer to
18 .
Do a check of the LED status indicator on the
charging station. If it shows damage in the
boundary wire, replace the damaged section
with new boundary wire.
Put the product in the charging station and
ECO mode is ena-
start the product.
Install the boundary wire in the correct direc-
tion around the island. Refer to
boundary wire on page 18 .
Put the product in the charging station and
make a new loop signal. Refer to
signal on page 22 .
Move the boundary wire and/or make islands
in the work area to increase the signal
strength.
Install the boundary wire to make all parts of
the work area maximum 15 m / 50 ft. from
the boundary wire.
Move the product to a level area.
To install the boundary wire on page
To install the
New loop
1622 - 001 - 03.03.2021
Advertisement
Table of Contents
