Table of Contents
Advertisement
Note:
LawnSense , it is recommended to
When using
make as much operating time as possible available for
LawnSense . Do not restrict the schedule more than
necessary. Also, check that the blade disc is clean and
that the blades are in good condition.
The first operation of the day is set by the schedule
settings. The product always completes 1 mowing cycle,
and then
LawnSense selects if the product will continue
to operate or not. In the factory setting this function is
disabled.
Note:
LawnSense is reset if the product does not
operate for more than 50 hours, or if a
settings is done. LawnSense is not changed if a Reset
of schedule settings is done.
3.10.7 Avoid collisions with Flymo mower
house
If you have installed a Flymo mower house
on the product and the mower house decreases when
you select
Avoid house collisions . In the factory setting
this function is disabled.
Note:
If
Avoid house collisions is selected it can result
in grass that is not cut around the charging station.
3.10.8 ECO mode
If
ECO mode is activated, it switches off the signal in the
boundary loop, the guide wire and the charging station,
when the product is parked or is charging. In the factory
setting this function is disabled.
Note:
ECO mode to save energy and avoid
Use
interference with other equipment, for example hearing
loops or garage doors.
Note:
To start the product manually in the work area,
push the STOP button before you remove the product
from the charging station. If not, the product can not be
started in the work area.
3.10.9 FrostSense
The grass is extra sensitive to wear if the yard is
FrostSense is activated, the
covered with frost. If the
product is not allowed to start to cut the grass if the
temperature is below 5° C / 41° F. In the factory setting
this function is disabled.
4
Available as accessory
22 - Installation
Note:
and there can be a delay compared to the ambient
temperature.
3.10.10 New loop signal
The loop signal is randomly selected to create a unique
link between the product and the charging station. In
rare cases, there may be a need to generate a new
signal, for instance if two adjacent installations have a
very similar signal. Put the product in the charging
station before you make a new loop signal.
3.10.11 PIN code
Reset of all user
The PIN code is a combination of 4 buttons on the
keypad.
Note:
button and the GO/Schedule buttons can be included in
the PIN code.
4
, the wear
3.10.11.1 To enter the factory PIN code
1.
Push the ON/OFF button (A).
2.
Push the GO/Schedule button (B).
3.
Push the GO button (C).
4.
Push the Park button (D).
Note:
EasiLife app.
3.10.12 Reset all user settings
Use this function to reset all user settings.
Note:
reset when you select
The frost sensor is located inside the chassis
The ON/OFF button, the Park button, the GO
A
D
C
You can change the PIN code in the Flymo
PIN code, Loop signal and Messages are not
Reset all user settings .
1622 - 001 - 03.03.2021
B
Advertisement
Table of Contents
