Update Of The Flymo Easilife App; Battery - Flymo EasiLife 500 GO Operator's Manual

Robotic lawn mower
Table of Contents

Advertisement

5.5 Update of the Flymo EasiLife app

Flymo regularly updates the Flymo EasiLife app. Update
the app on App Store or on Google Play to make sure
that you have the latest version.

5.6 Battery

WARNING:
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery. In the event of
leakage of electrolyte flush with water and
seek medical help if it comes in contact with
the eyes etc.
WARNING:
recommended by the manufacturer. Product
safety cannot be guaranteed with other
batteries. Do not use non-rechargeable
batteries.
CAUTION:
The battery must charge a
complete cycle before winter storage. If the
battery is not fully charged it can be
damaged and in certain cases be rendered
useless.
If the operating time for the product is shorter than
normal between charges, this indicates that the battery
is getting old and eventually needs replacing.
Note:
Battery life is dependent on the length of the
season and how many hours a day the product is
operating. A long season or many hours of use a day
means that the battery must be replaced more regularly.
The battery is fine as long as the product maintains a
well-cut lawn.
5.6.1 To replace or to remove the battery
WARNING:
CAUTION:
Do not touch the circuit
boards.
1.
Push the ON/OFF button for 3 seconds to switch
off the product.
2.
Make sure that the product is disabled. The
indicator lamp on the ON/OFF button is not lit
1622 - 001 - 03.03.2021
Only charge the product
Use only original batteries
Use protective gloves.
when the product is disabled. Refer to
indicator on the keypad on page 6 .
3.
Turn the product upside down. Put the product on
a soft and clean surface to prevent scratching the
product.
4.
Remove the 10 screws with a Torx 20.
5.
Carefully lift the lower section of the chassis and
put it adjacent to the upper chassis.
CAUTION:
connected to the main board.
6.
Remove the screw for the battery holder.
7.
Push the clips and lift up the battery holder.
LED status
Be careful, the cable is
T20
Maintenance - 29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Easilife go

Table of Contents