Table of Contents
Advertisement
5.3 Replace the blades
WARNING:
the right type. Flymo can only guarantee
safety when using original blades. Only
replacing the blades and reusing the screw
can result in a screw wearing during
mowing. The blades can then be propelled
from under the body and cause serious
injury.
Replace worn or damaged parts for safety reasons.
Even if the blades are intact, they should be replaced on
a regular basis for the best mowing result and low
energy usage. All 3 blades and screws must be replaced
at the same time to obtain a balanced cutting system.
Use Flymo original blades embossed with the crowned
Warranty on page 44 .
H-mark logotype, refer to
5.3.1 To replace the blades
1.
Push the STOP button.
2.
Push the ON/OFF button for 3 seconds to switch
off the product.
3.
Make sure that the indicator lamp on the keypad is
not lit.
4.
Turn the product upside down. Put the product on
a soft and clean surface to prevent scratching the
product.
5.
Remove the 3 screws. Use a straight slot or cross-
tip screwdriver.
28 - Maintenance
Use blades and screws of
6.
Remove each blade and screw.
7.
Attach new blades and screws.
8.
Make sure that the blades can pivot freely.
5.4 Firmware update
If service is done by Flymo service then available
firmware updates are downloaded to the product by the
service technician. Owners of Flymo products can
update the firmware if this is initiated by Flymo.
Registered users are in that case notified.
5.4.1 To update the firmware
1.
Remove the rubber plug.
2.
Connect a USB printer cable (USB A and USB B
contacts) in the product and your computer. The
USB printer cable is available as an accessory.
3.
Go to www.flymo.com/uk, search for and download
the firmware update tool and follow the
instructions.
4.
Remove the USB printer cable.
5.
Attach the rubber plug and make sure that it seals
fully.
CAUTION:
Make sure that the rubber
plug seals fully to prevent moisture.
1622 - 001 - 03.03.2021
Advertisement
Table of Contents
