Table of Contents
Advertisement
Message
Cause
Empty battery
The product cannot find the charging station.
The battery is at the end of its life cycle.
The antenna of the charging station is defec-
tive.
The charging plates on the product or con-
tact plates on the charging station are defec-
tive because of corrosion.
Wrong PIN code
Incorrect PIN code has been entered.
No drive
The product has got caught in something and
has been slipping.
The work area includes a steep slope.
The guide wire is not put diagonally in the
slope.
Wheel motor overloa-
Grass or other object around the drive wheel. Remove grass or object from the drive
ded, left/right
Collision sensor
The front wheels on the product are blocked.
problem
Charging station
The contact between the charging plates on
blocked
the product and the contact plates on the
charging station is not good. The product has
made a number of tries to charge.
An object prevents the product to enter the
charging station.
The charging station is tilted or bent.
The guide wire is not installed correctly.
Stuck in charging sta-
An object prevents the product to move out
tion
from the charging station.
Upside down
The product is in an incorrect position, the
product is tilting too much or is upside down.
Lifted
The lift sensor has been enabled because
the product has been lifted.
32 - Troubleshooting
Action
Change the position of the guide wire. Refer
To install the guide wire on page 18 .
to
Replace the battery. Refer to
page 29 .
Do a check if the indicator lamp in the charg-
ing station flashes red. Refer to
lamp in the charging station on page 36 .
Clean the charging and contact plates using
a fine grade emery cloth. If the problem stays
speak to your Flymo service.
Enter the correct PIN code. Speak to your
Flymo service if you forget the PIN code.
Free the product and correct the cause of
problem. If it is because of wet grass, wait
until the lawn is dry before you use the prod-
uct.
Steep slopes must be isolated. Refer to
examine where to put the boundary wire on
page 13 .
Make sure that the guide wire is installed di-
agonally across the slope. Refer to
ine where to put the guide wire on page 16 .
wheel.
Free the product and correct the cause of
problem. If the problem stays speak to your
Flymo service.
Put the product in the charging station and
make sure that the charging plates and con-
tact plates are connected.
Remove the object.
Put the baseplate on level ground.
Install the guide wire correctly. Refer to
install the guide wire on page 18 .
Remove the object.
Put the product in the correct position.
Make sure that the product body can move
freely around its chassis. Remove or create
an island around objects that can cause the
chassis to be lifted. If the problem stays
speak to your Flymo service.
1622 - 001 - 03.03.2021
Battery on
Indicator
To
To exam-
To
Advertisement
Table of Contents
