Table of Contents
Advertisement
3.10.3 Lawn Coverage and PassageSense
If the work area includes remote parts that are
connected with narrow passages, the
and
PassageSense function are useful to be able to
maintain a well-cut lawn in all parts of the yard. The
Lawn Coverage function is used to guide the product to
remote parts of the work area. The
function is used for narrow passage mowing. A guide
wire must be installed to use these functions. You can
set a maximum of 3 remote areas.
Lawn Coverage function the product first
With the
follows and then leaves the guide wire after a certain
distance and starts to mow the lawn.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
A
The
PassageSense function is suitable to mow narrow
passages of 60 cm - 1.5 m / 2 ft. - 4.9 ft. width. The
product moves in a pattern to cover the passage width.
PassageSense at the set
The product starts the
distance from the charging station. When the product
reaches the end of the narrow passage, the product
continues and cuts the lawn as normal.
Note:
To prevent that the grass in the narrow passage
is worn, Flymo recommends to set a low percentage for
PassageSense .
the
In the factory settings the product follows the guide wire
20% of the time for 99 m / 325 ft, or until the product
reaches the connection with the boundary wire. The
remaining time the product starts to cut at the starting
point. In the factory settings the
disabled.
3.10.4 Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance. Then the product
moves rearward and changes direction. The factory
1622 - 001 - 03.03.2021
Lawn Coverage
PassageSense
C
B
PassageSense is
setting is 32 cm / 12 in. You can select a distance of
20-40 cm / 8-15 in.
Note:
If you change the distance for
the distance will change along the boundary wire in all
parts of the work area.
3.10.5 Starting point
This function allows you to control how far the product
drives along the guide wire from the charging station
before it starts operating. The factory setting is 60 cm / 2
ft.
Note:
The product straddles the guide wire from the
charging station to the starting point. Keep as short
distance to the starting point as possible to reduce the
risk of tracks forming on the lawn.
If the charging station is put in a small space area, for
example between flower beds, set the starting point
where the distance to the boundary wire is minimum 60
cm / 2 ft.
A
B
A) Starting point
B) Minimum distance 60 cm / 2 ft (perpendicular to the
guide wire).
3.10.6 LawnSense
LawnSense automatically adjust the cutting time to the
growth of the grass. The product is not permitted to
operate more than the schedule settings. You get set
how frequently the product cuts the grass when you use
LawnSense . There are 3 frequency levels: Low , Mid and
High . The higher the frequency, the more sensitive the
product is to the grass growth. That is, if the grass
growth is high then the product can operate longer.
Drive Past Wire ,
Installation - 21
Advertisement
Table of Contents
