Keyboard Wake-Up - Supermicro SUPER P4SBA+ User Manual

S
UPER P4SBA+/P4SBA/P4SBM User's Manual

Keyboard Wake-Up

The JPWAKE jumper is used to-
gether with the Keyboard Wake-
Up function in BIOS. Enable both
the jumper and the BIOS setting to
allow the system to be awakened
up by depressing a key on the
keyboard. See Table 2-19 for
jumper settings. Your power sup-
ply must meet ATX specification
2.01 or higher and supply 720 mA
of standby power to use this fea-
ture.
2-8 Game Port, Parallel Port, Floppy Diskette
Drive, Hard Disk Drive and AGP Connections
Use the following information to connect the floppy and hard disk drive
cables.
• The floppy disk drive cable has seven twisted wires.
• A red mark on a wire typically designates the location of pin 1.
• A single floppy disk drive ribbon cable has 34 wires and two connectors to
provide for two floppy disk drives. The connector with twisted wires always
connects to drive A, and the connector that does not have twisted wires
always connects to drive B.
• The 80-wire ATA66/100 IDE hard disk drive cable that came with your
system has two connectors to support two drives.
should be used to take advantage of the speed this new technology
offers. The blue connector connects to the onboard IDE connector inter-
face and the other connector(s) to your hard drive(s). Consult the docu-
mentation that came with your disk drive for details on actual jumper
locations and settings for the hard disk drive.
T a b le 2 -1 9
K e yb o a rd W ak e -U p
J u m p e r S e tting s
(J P W A K E )
Jumper
P osition
1-2
2-3
2-14
D efinition
D isabled
E nabled
This special cable