Table of Contents
Advertisement
S
UPER P4SBA+/P4SBA/P4SBM User's Manual
2-2
Processor and Heat Sink Fan Installation
!
IMPORTANT: Always connect the power cord last and always remove it
before adding, removing or changing any hardware components.
sure that you install the processor into the CPU socket before you install the
CPU heat sink.
Installation of the Processor and Heatsink
1. Locate the following components, which are included in the shipping
package.
Clips (2)
Note: The CPU heatsink fan with clips is included only with the retail ver-
sions of the P4SBA and P4SBM, and not with the P4SBA+. If you buy a
boxed Intel Pentium 4 478/Northwood processor it should include a heatsink,
fan and retention mechanism. If you buy a processor separately, use only
a Supermicro or Intel certified heatsink and fan.
2. Insert the white pegs into the black an-
chors.
Do not force the white pegs all the
way in - about 1/3 of the white pegs should
be inside the black anchors.
chassis that do not have four CPU retention
holes.)
3. Place a retention bracket in the proper position
and secure it by pressing two pegs into the reten-
tion holes until you hear a *click*.
sound indicates that the peg is locked and secured.
4. Secure the other retention bracket into position by repeating Step 3.
When handling the
direct pressure on the label area of the fan.
(These are for
processor package, avoid placing
Bracket in
position
The clicking
2-2
Make
Bracket (1)
Advertisement
Table of Contents
