Table of Contents
Advertisement
2-4
Installing DIMMs
Exercise extreme care when installing or removing DIMM
Memory Module Installation (See Figure 2-2)
1.
Install SDRAM memory modules into DIMM slots.
2.
Insert each memory module vertically into its slot. Pay attention to
the two notches along the bottom of the module to prevent inserting
the DIMM incorrectly.
3.
Gently press down on the memory module until it snaps into place.
4.
Three PC 133 SDRAM sockets support up to 3GB PC133 unbuffered
SDRAM. ECC type memory is supported. PC133 and PC100 memory
are both fully supported at their respective speeds.
Figure 2-2a.
To Install:
Insert module
vertically and
press down
until it snaps
into place.
Release
Pay attention
to the two
notches.
CAUTION
modules to prevent any possible damage.
Side View of DIMM Installation into Slot
PC100
Notches
Tab
DIMM
Note: Notches
should align
with the
receptive points
on the slot
DIMM Slot
2-5
Chapter 2: Installation
PC100
Notches
Release
Tab
Advertisement
Table of Contents
