Installing And Removing The Memory Modules; Installing & Removing Dimms; Removing Memory Modules - Supermicro X10DRS-2U User Manual

2-5

Installing and Removing the Memory Modules

Note: Check Supermicro's website for recommended memory modules.
Exercise extreme care when installing or removing DIMM
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with P1-
DIMMA1. (For best performance, please use memory modules of the same
type and speed in the same channel.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.

Removing Memory Modules

Press both notches on the ends of the DIMM module to unlock it. Once the DIMM
module is loosened, remove it from the memory slot.
CAUTION
modules to prevent any possible damage.
X10DRS
REV:1.03
BIOS
LICENSE
BAR CODE MAC CODE
SAS CODE
2-13
Chapter 2: Installation
Notches
Release Tabs