Advertisement
Available languages
Available languages
N
otes
• Graphics shown in this quick reference guide are for illustration only. Your components may or
may not look exactly the same as drawings shown in this document.
• Refer to Chapter 2 of the User's Manual for detailed information on jumpers, connectors, LED
indicators, memory support and CPU/motherboard installation instructions.
CPU Installation
With a T20 Torx-bit screwdriver,
1
unscrew the screws holding down thge
Force Frame in the sequence of 3-2-1.
Force Frame
Screw #3
Screw #2
Remove the PnP Cover Cap from the
4
socket.
Heatsink Installation
Lower the heatsink down till it rests securely over
1
the four screw holes on the socket frame of the
CPU Package.
Remove the External Cap from the
2
Rail Frame by pulling it out of the rail
guides on the Rail Frame.
Rail Frame
Screw #1
Gently lower the Rail Frame down onto
5
the socket until it clicks into place.Then
gently lower the Force Frame down onto
the Rail Frame and hold it in place until
it is seated in the socket housing.
The processor is shipped from the
3
factory with the Carrier Frame pre-
assembled. Slide the Carrier Frame/
Processor Assembly downwards to the
bottom of the Rail Frame.
Carrier Frame/Processor Assembly
External Cap
Re-screw the screws in the sequence
6
of 1-2-3. When finished, the socket
Force Frame will secure the processor.
Screw #3
Screw #2
As illustrated, tighten the four screws down on the
2
heatsink in a diagonal pattern till it is secured.
Screw #1
Screw #3
Screw #1
Screw #4
Screw #2
Advertisement
