Fujitsu AR C72LHTA Series Design & Technical Manual page 75

SCREW POSITIONS ON THE SIDES OF SNOW HOOD
„ „
Left-side View
NOTES ON INSTALLING SNOW HOOD
„ „
Front View
Rear View
Make holes in the rear
panel so as to provide
good ventilation.
Drilling holes in 20% or
more of the rear panel is
recommended.
Chamfered area
Notch the upper part of
snow hood so that it can be
mounted in place avoiding
the column.
Cover with a plate so there is
no gap.
- (02 - 34) -
Since there is the head
of the screws at this part,
cut a notch in the flange
of the snow hood
Be careful that
the flange of snow
hood does not get
onto the stepped
area.
Install the snow
protection
foundation for
the inlet not to be
buried in snow.
To avoid snow accumulation on the
snow protection foundation, make the
foundation as wide as the cabinet.
(Unit : mm)
Right-side View
(Unit : mm)
Snow protection
foundation