Fujitsu AR C72LHTA Series Design & Technical Manual page 68

(6) Again, referring to the Settings List shown below, press the SELECT button (SW108), and
display the code number of the function you want to set on the LED104.
Ex.) To select the Low noise operation setting.
LED105 LED104
Next, press the ENTER button (SW109), and confirm the selection of the mode you want to set.
LED105 LED104
A flashing display on the LED104 changes to an illuminated display. Settings are complete with
the procedures described above.
(7) To set another function, press the ENTER button (SW109) in the setting completed status
shown in step (5) above.
LED105 LED104
Repeat steps (5) and (6) above to set other functions.
When all settings are complete, perform the operation described in sttep (8) above to exit.
(8) To exit FUNCTION SETTING, press the ENTER button (SW109) in the setting completed
status shown in step (6) above.
LED105 LED104
*2
Then, press the MODE/EXIT button (SW107) to exit FUNCTION SETTING MODE.
LED105 LED104
LED105 LED104
LED105 LED104
LED105 LED104
LED105 LED104
*2: 5 seconds after, even if ENTER button (SW109) is not pressed,
LED105 changes to a flashing display automatically.
LED105 LED104
- (02 - 27) -