Fujitsu AR C72LHTA Series Design & Technical Manual page 35

(5) Press the TIMER SET button to confirm the setting. Press the TIMER SET button for a few seconds until the setting value stops
flashing. If the setting value display changes or if "- -" is displayed when the flashing stops, the setting value has not been set correctly.
(An invalid setting value may have been selected for the indoor unit.)
(6) Repeat steps 2 to 5 to perform additional settings. Press the SET TEMP. buttons (
more than 5 seconds to cancel the function setting mode. In addition, the function setting mode will be automatically canceled after 1
minute if no operation is performed.
(7) After completing the FUNCTION SETTING, be sure to turn off the power and turn it on again.
• After turning off the power, wait 30 seconds or more before turning on it again. The Function Setting will not become active
unless the power is turned off then on again.
CONTENTS OF FUNCTION SETTING
„ „
• Follow the instructions in the Local Setup Procedure, which is supplied with the remote control, in accordance with the installed
condition.
After the power is turned on, perform the Function Setting on the remote control.
• The settings may be selected between the following two: Function Number or Setting Value.
• Settings will not be changed if invalid numbers or setting values are selected.
1)
2) Room temperature control for cooling
3) Room temperature control for heating
4)
5)
6)
7) Room temperature sensor switching (Aux
1) Static pressure
Select the appropriate static pressure according to the installation conditions.
Setting Description
Normal (72Pa)

Low static pressure (50Pa)
High static pressure 1 (150Pa)
High static pressure 2 (200Pa)
High static pressure 3 (250Pa)
2) Room temperature control for cooling
Depending on the installed environment, correction of the room temperature sensor may be required.
Select the appropriate control setting according to the installed environment.
Setting Description
 Standard
Higher control
Slightly higher control
Slightly lower control
Lower control
Static pressure
Auto restart
Room temperature sensor switching
Cool air prevention
(  . . .Factory setting)
Function
Setting Value
Number
00
02
21
03
04
05
(  . . .Factory setting)
Function
Setting Value
Number
00
01
30
02
03
04
) ( ) and FAN button simultaneously again for
! CAUTION
.)
- (01 - 32) -