Fujitsu AR C72LHTA Series Design & Technical Manual page 36

3) Room temperature control for heating
Depending on the installed environment, correction of the room temperature sensor may be required.
Select the appropriate control setting according to the installed environment..
Setting Description
 Standard
Higher control
Slightly higher control
Slightly lower control
Lower control
4) Auto restart
Enable or disable automatic system restart after a power outage.
Setting Description
Enable

Disable
* Auto restart is an emergency function such as for power failure etc. Do not start and stop the indoor unit by this function in
normal operation. Be sure to operate by the control unit, or external input device.
5) Room temperature sensor switching
(Only for wired remote controller)
When using the Wired remote controller temperature sensor, change the setting to "Both" (01).
Setting Description
Indoor unit

Both
*00: Sensor on the indoor unit is active.
01: Sensors on both indoor unit and wired remote controller are active.
*Remote controller sensor must be turned on by using the remote controller.
6) Cool air prevention
This setting is to disable the cold air prevention function during heating operation. When disabled, the fan setting will always follow the
setting on the remote controller. (Excluding defrost mode)
Setting Description
 Enable
Disable
7) Room temperature sensor switching (Aux.)
o use the temperature sensor on the wired remote controller only, change the setting to "Wired remote controller" (01). This function will
only work if the function setting 42 is set at "Both" (01)
Setting Description
Both
Wired remote controller

(  . . .Factory setting)
Function
Setting Value
Numbe
00
01
31
02
03
04
(  . . .Factory setting)
Function
Setting Value
Number
00
40
01
(  . . .Factory setting)
Function
Setting Value
Number
00
42
01
(  . . .Factory setting)
Function
Setting Value
Number
00
43
01
(  . . .Factory setting)
Function
Setting Value
Number
00
48
01
- (01 - 33) -